DOES YOUR GARAGE DOOR HAVE A MIND OF ITS OWN? DON’T WORRY. THERE’S SOMETHING YOU CAN DO!

Is your garage door opening and closing at random? There are numerous reasons this is going on:

 

1. First, test the transmitter frequency. A neighbor’s remote may have accidentally been programmed to the exact same frequency as yours. If that’s the case, erase the remote control from the memory of your garage door opener, and then reprogram the keyless entry and remote control.
2. Second, inspect the transmitter. It might be wedged under something that inadvertently pressed your remote control mechanism, which means, somewhere, a button is stuck. The transmitter may be sitting under something you forgot you left in your automobile, or underneath something else you left close by. If the LED light by the learn button is flashing continuously, then your garage door opener is receiving a steady signal from your remote control. (You’ll find the learn button above the antenna wire hanging from the motor head, or under the light cover. It’s either red, orange, purple, green, or yellow.) Take out the batteries from your remote, and if the light stops flashing, then the problem is a stuck button.
3. If neither of these is the culprit, there may be a short in the wall-mounted door control, which means that unwanted signals are going out to the garage door opener or to the logic board (that is, the circuit board).

• If your garage door opener activates by itself while the wall-mounted door control panel wires are disconnected, you’ll probably have to replace the receiver logic board.
• If the opener doesn’t activate by itself while the wall-mounted door control panel is disconnected, then, in all likelihood, you’ll need to replace the wires to your wall-mounted door control panel.

 

4. Besides a short in the logic board, there could be a short in the wall button wiring, the wired keypad, the wall button, or the garage door opener remote; or, there are some other electronic issues to be dealt with.

 

5. Your remote might be emanating random signals. This is often a sign that the batteries are nearly worn out, or that the remote is faulty.

 

6. A police radio, CB radio, local radio station, or radio tower can make a garage door open and shut by itself.

 

 

DIY

 

There are some additional problems you can likely resolve all on your own. If your garage door ever goes on the blink, there are many possibilities for the difficulties you’re facing:

 

Does the garage door opener run for several seconds, but then turn off? Often this will happen on older garage doors. The garage door is shut, and the garage door motor tries to lift it, but it still doesn’t move. First, look at the springs. If the springs aren’t broken, then examine the track for any grime or minute obstacles. If neither of these is the issue, maybe your garage door is the kind that has a built-in lock that’s engaging by mistake.

 

Does the garage door not open with the remote? There are several reasons this is occurring. 1. You could be out of range from your garage door. 2. Perhaps you have to recharge or replace your batteries. 3. The garage door motor’s antenna is likely damaged, or it’s blocked from the signal. 4. Your remote must be reprogrammed.

Does the garage door opener run, but the garage door still will not open? If there is a power outage, your garage door opener has a disconnect switch, so that you can manually close or open the garage door. This switch is usually attached to a rope or knob, which can sometimes unintentionally get unhooked. Open or shut your garage door all the way, and then reattach the hook securely. Your transmitter should be back to normal.

 

 

More Complicated Problems, Calling for Professional Attention

 

Does the garage door slam with a loud bang? Then in all probability, you have a broken garage door spring, which isn’t offsetting the garage door’s weight properly. Or, the cables might be broken. In either case, this is bad. Call a garage door repair technician right away.

 

Does your garage door only go part way down, but open again? A garage door is designed with a reversing mechanism to stop it from smashing an object in its path. The reversing instruction is activated by any item that is blocking the garage door’s path ~ a bicycle, a trash can, or a box, for instance. Another possibility is that there’s a build-up of debris on the tracks ~ a tiny object or grime ~ which keeps the rollers from moving. The expertise of a garage door repair professional is required.

 

The garage door track may be out of alignment. This is also a big problem. When the metal track isn’t in alignment, the garage door isn’t going to be moving at all. Check for any gaps between the rail and the rollers, and also look closely to see if there are any bends in the rails. The garage door’s significant weight will worsen all these issues eventually, so don’t procrastinate! Your garage door is bound to grow more and more dangerous. It’s time to hire a garage door repair expert.

 

 

It’s never a good idea to try to adjust your garage door yourself ~ unless you’re an engineer! If your garage door isn’t serviced properly, the garage door springs can go straight through a wall! Furthermore, there’s the possibility of serious injury, and even death. The garage door bottom brackets, cables, and drums will likely also need adjustment. It’s not worth it to take any risks. So unless you already know exactly what you’re doing, then your best bet is to hire a local garage door repair technician. If you live anywhere in Roswell, Georgia, then consider hiring a reputable garage door repair company you can count on, such as a staff mobile garage door repair specialist at Roswell Garage Door Repair, where free consultations are available.

Article source here: DOES YOUR GARAGE DOOR HAVE A MIND OF ITS OWN? DON’T WORRY. THERE’S SOMETHING YOU CAN DO!

Roswell Garage Door Repair: What to do when a garage door won’t open or close with the remote control

Electronic garage door openers are a convenience that nobody wants to live without. Given the fact that the garage is the main point of access of most homes, you want to be able to enter and exit through it without any hassles.

While you can usually expect all your door’s components to work for several years with no problems whatsoever, they’re not immune to the occasional glitch.

If you’ve found that you’re no longer able to open or close your garage door with a remote control, there are a few things to check before calling an expert. After all, your issues could be as simple as needing a battery change, or you might be dealing with more serious damage.

With that in mind, here is what we advise homeowners to do in this situation.

Test the wall switch 

See if you can open the door by pressing the button by the opener. If yes, then the problem lies on the remote control itself. Otherwise, you’ll either need to replace the opener battery, or you might need to get a technician to repair the motor for you.

If you have more than one remote control

It’s always best to check them both. If one of them works, but the other fails, you just need to replace the battery. You’ll most likely have purchased both transmitters at the same time, so don’t rule out the possibility of both needing a battery change. Open up the back of the remote (depending on your type of opener, you might need a screw driver to do this) and put a brand-name battery inside – avoid the cheaper generics as they will not last. If that doesn’t fix your issues, then proceed to the next step.

Inspect the door for damage

There are various maintenance checks you can do yourself before calling a garage door repairs technician. Here are the key things to look out for:

• Is your door quite visibly out of balance? In some cases, you might be able to tap it back into position. But, most often, you’ll need an experienced repairs technician to do the job. If in doubt, leave it to the professionals – you don’t want any unnecessary damage on your hands.
• Check the roller bracket for any broken pieces, signs of rust, damaged springs or rollers. This is very much a “look, don’t touch” procedure: broken springs and rollers are very dangerous to handle without proper training and tools, as they will leave your garage door quite vulnerable to collapsing.
• Inspect the area around the photo eye for any built up dirt – if you can see debris and gunk amassing in the area, clean it up with a streak-free cleaning solution and some warm water. You’ll find the right cleaner for the job at your local garage door repairs business.
• Another check for photo eyes: make sure they’re not misaligned. In some cases, you can realign them yourself using a spirt level (just remember to measure the angle from the ground on each side). If they’re too misaligned, however, you’ll need to ask a technician to do it.
• Try to lift up the door manually. It shouldn’t be heavy to lift up – if you struggle to open it or it won’t stay in place, your door might be out of track. In this instance you’ll need to contact a garage door repairs professional immediately.

Call an expert

When all things fail, your best option is to call a garage door repairs technician to inspect your opening and closing issues.

All credible professionals will have experience, training, and a full inventory of tools by their side. You can expect quality repairs and replacements, for very affordable prices and with a good sense of immediacy in the most urgent cases. In fact, most locally-based operators will provide 24/7 emergency assistance for their customers, and won’t charge for initial consults or price quotes.

Take the time to do some research before settling on a garage door repair service. See if anyone you know (friends, family, neighbors, acquaintances) can recommend any businesses in your area, and note down specific companies for your inquiries. Always hire a local operator, with a fully verifiable address. Where possible, try to consult with them in person – though talking on the phone is perfectly reasonable too. Ask the business about product warranties, client references (good professionals won’t balk at this), minimum callout charges and a full cost breakdown for whatever repairs you might have in mind. Online reviews can help you glean a business’s reputation too, and casually asking how long the company has been operating might give you an indication of whether they’ll be able to uphold their warranties. A quick search for a company through the Better Business Bureau will show you if any complaints have been laid out against them, and checking their credentials against the manufacturers they work with could help out too.

What about homeowners in Roswell, GA? You can always count on the Roswell Garage Door Repair crew to set your problems straight. Talk to our licensed, insured and field-tested technicians to find out more about our solutions. Tell us your concerns, and we’ll try our best to point you in the right direction – if needed, we can come to inspect the damage at your convenience.

No matter where you’re based, though, finding the right professional for the job is as simple as making the right inquiries. Clarify everything with the person you’re consulting, and don’t rush the hiring process.

We hope this guide helps you make sense of a malfunctioning opener, and the precautions to take if any issues occur. Whether you’re dealing with a remote control that needs to be replaced, a faulty battery that needs changing, or a more complex repair that needs to be addressed, these quick checks will guide you towards the right solutions. Always get in touch with a qualified professional in your area if any issues arise, or if you have any pressing queries and concerns. From there, everything will be back to operating smoothly shortly.

Article source here: Roswell Garage Door Repair: What to do when a garage door won’t open or close with the remote control